Peak Optics

contactshipcall

Shopping Cart  [more]

Your cart is empty.

Peak 2046 Light Box for 2026 series

Peak 2046 Light Box for 2026 series

Light Box for 2026 series Peak Hand/Microfilm viewers.

The Light Box is a new item with an auxiliary lighting source to be used where the supply of light is not sufficient when you use the Loupe 8X with Puncher & Holder or Microfilm Viewers 15X and 20X, and Hand Viewer 8X (item 2026). (Two kinds of white diffusing plastics are used for the light box).

The plastics with a hole in the center is for No. 2018-SET and the one without hole is for No. 2026 series).

When you want to use the light box for No. 2018-SET, 2018 loupe, 2018-PH (Puncher and Holder)

It is very simple and easy to connect the Light Box to the Microfilm Viewers.

A small rectangular metal plate is enclosed for the purpose of the con­nection. Put the small metal plate with a paper cover upward horizontally just on the magnet of Light Box. Then, peel the paper cover from it and fit the Microfilm Viewer, sliding it into the inner side along the both guides, on the white diffusing plastics until it stops at the end. Press the Viewer down from above so that metal plate with adhesive on the surface will stick to the bottom of the Viewer. Now, you can use the Light Box properly. When you like to detach the Microfilm Viewer from the light box, just lift it up with light box holding in your hand.

Size: 50 x 81 x 25 mm
Battery: R6P x 2
Bulb: 2.5V 0.3a
New Weight: 50 gm

  • Model: OPT-P20462026
  • Manufactured by: Peak Optics/Japan

$53.00

Add to Cart:
Copyright © 2017 GWJ Co. All rights reserved.
Other products and companies referred to herein are trademarks or registered trademarks of their respective companies.
**Prices subject to change without notice.**

PIA Member

For your convenience, we accept these credit cards:
Credit Card Logos